Go Down

Topic: I want to know that weather board is short circuited or not. (Read 519 times) previous topic - next topic

Respected Sir,

Sir, I want to know that i have connected a battery of 12v, 1400mAh to icsp header by mistake. So i want to know that my board is short circuited of not. Or if Short circuited then how can i repair it by myself.
And i also want to know that how can we interface PID controller with it...

Yours' Faithfully
Pulkit Vijay

sir,
we used ARDUINO DECIMILLA[ATMEGA168] microcontroller board.
here on connecting with the usb to pc. pin 13 LED is blinking .
THEN we upload a  blink led programme on arduino enviorment. LED  blinks red.
compile is done.and uploading I/O shows error.
when we remove ATMEGA168 from the board then 13 pin led stops blinking .
So sir i want to know that weathermy Atmega168 is Damaged aur its Driver or another problem...
if it is a driver problem then  from where should i get the driver.

Pulkit vijay

CrossRoads

What pin did you put 12V onto? The 5V pin?
If so, you likely damaged the 28-pin surface mount part behind the USB connector - that is a very hard part to replace unless you have special tools.

Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Grumpy_Mike

Do you see the correct serial port in the tools menu?

If not it sounds like you have damaged the USB / Serial bridge chip. They are difficult to replace because you need surface mount rework equipment.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy