Go Down

Topic: rfid Card acknowledgement (Read 1 time) previous topic - next topic


Hi there… I have a rfid reader and  a XBee pro shield from cooking-hacks.com. when I pass a card over the reader the red led flashers can I tell it to send voltage to a pin when this happens …..thanks


can I tell it to send voltage to a pin when this happens

Yes but only if you connect the signal flashing the red LED to an arduino (or something else)

You question is a bit vague, so it matches my answer.

For a more specific answer please provide links to the equipment yo are using, along with how you are wiring it up to the Xbee. It would also be useful to know what you want to do.

Most RFID readers have a separate input to flash the red LED because you normally want to flash the red when you deny access and green when you grant it.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131