Pages: 1 [2]   Go Down
Author Topic: Ethernet / UDP controlled Motors and Servo  (Read 2205 times)
0 Members and 1 Guest are viewing this topic.
Kent, UK
Offline Offline
Newbie
*
Karma: 0
Posts: 28
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Oh I see, and understand it all, Thanks for the help.
Logged

Kent, UK
Offline Offline
Newbie
*
Karma: 0
Posts: 28
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Here is a code update,
It is now to large to post, so it has been attached ...
I'm not sure if it is any good to anyone else, its for a wifi controlled tank all working apart from I think I am out of PWM outputs as I can not control no more then 3 PWM outputs, can anyone tell me why?

And before someone tells me its because I have left servo 2 out, I have done it to make the code work, as if I use PWM 3, 10 or 11 the Arduino stops working,

Thanks

* wifi_tank.ino (11.42 KB - downloaded 13 times.)
Logged

Pages: 1 [2]   Go Up
Jump to: