Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: using Arduino UNO  (Read 409 times)
0 Members and 1 Guest are viewing this topic.
Fowelld
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
« on: October 06, 2011, 01:29:50 pm »
 Bigger Bigger Smaller Smaller Reset Reset
I have been trying to use the help but unable to access it.
My question is I have been trying to use the servo.pde but I cannot compile it until I have inserted the '#include <math.h>' at the begining before it compiles.  I am also having trouble with controling a servo of any kind.
Can anybody help?
Logged

johnwasser
Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 108
Posts: 6607
View Profile
« Reply #1 on: October 06, 2011, 02:04:16 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Where did you get servo.pde?  I don't think it's part of Arduino 0.22.
Logged

westfw
SF Bay Area (USA)
Offline Offline
Faraday Member
**
Karma: 80
Posts: 5513
Strongly opinionated, but not official!
View Profile
« Reply #2 on: October 06, 2011, 07:26:27 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Quote
I cannot compile it until I have inserted the '#include <math.h>'

Using linux?
This (or something very similar) is a known problem using some of the newer avr-gcc and avr-libc packages under linux.

Discussion (mixed with flamage, justification, and such) here: http://arduino.cc/forum/index.php/topic,68785.0.html
Logged

Fowelld
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
« Reply #3 on: October 08, 2011, 08:37:34 am »
 Bigger Bigger Smaller Smaller Reset Reset
I used servo from Arduino 0.22 in examples/servo/sweep or knob.
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: