Pages: [1]   Go Down
Author Topic: Burn Bootloader on Arduino Mega  (Read 366 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 14
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think I have corrupted my Bootloader on my Arduino Mega 1280 board. I just got a usbtiny programmer and was messing around with it and I believe I messed up the bootloader:( For now, I cannot down load sketches via usb using the Arduino IDE version 22. So what is the command line magic incantantion to load the default Bootloader using avrdude with a usbtiny programmer, so I can de-brickify my Arduino?
Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17301
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

You can burn the bootloader for a mega1280 using a USBtiny directly from the Arduino IDE. Just select the mega1280 board in the tools menu and then the Burn Bootloader selection from the same menu.

Lefty

Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 14
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I tried that and the burn failed. So I was hoping to do it directly from avrdude. Anyone have the command line for that?
Logged

Pages: [1]   Go Up
Jump to: