Go Down

Topic: Dynamic Pad for Ableton and other Midi Progs (Read 885 times) previous topic - next topic

It is nice to have some hardware interface to control a music Programm like Ableton without the mouse.

I found a Midi-controller project that use a serial to midi converter on the pc side to transform the incomming message.
It is also possible to change the bootloader of the arduino to get a hid device, so the serial to midi converter could be removed.

The test programm was designed to send controller messages, i just rewrote it for a piezo drumpad incomming signal.
Digital buttons are also available just uncomment the sending note line.
On pin 13 must be the oposit logic with a pull down, its because of the arduino board design.


here is the midified code:

so just have fun.

JoKieStyler

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy