Pages: [1]   Go Down
Author Topic: G-code interpreter  (Read 499 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
Karma: 6
Posts: 229
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I can't find any g-code interpreter that works with 2 wire controlled drivers (not DIR and STP but two wires).

So one for drivers like this one or for unipolar motors

Aventgps supposedly modified gcode interpreter used by the reprap project to work with 2 wire dirvers.
Here is that thread ->,7986.msg63636.html#msg63636
I say supposedly because he posted links to un modified interpreter. Now I am lost

I tried contacting him directly but with no success

So does this gcode interepreter for 2 wire drivers exist?

Pages: [1]   Go Up
Jump to: