My application requires the use of a small battery
run timer2 with a 32.768 khz crystal when sleeping which should get me down to 1uA
Any ideas how or why I would get those errors when I load the sketch?
I am attempting to get the AVR to sleep at 1uA (unsuccessfully)
No other changes to the bread board or sketch were made so I am pretty sure it was moving the cap closer to VCC that did it.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16