Go Down

Topic: 2 Board Arduino PCB work in progress... (Read 834 times) previous topic - next topic


Hey I've been designing a 2 layer arduino board (still working on it) but any suggestions/improvements welcome.
Plz check the link for more info and pics


Routed?  I'm jealous!!  I have to etch my boards and YOU get to route them. Did you build your CNC?

Congrats on a job well done.




link worked for me last night and still works this morning on a different computer.  Not sure why itdoesn't work for you over there.

Have you tried just pasting the url in?

Ken H>


Yeah just worked out the issue, it is the stupid internet where I am, I will try it when I get home :P



No I don't have my own CNC, I design the board on Pad2Pad then I order them online. So I'm not sure if anybody read my comments, but is the general idea of the board good? I just wanted a nice lil board with an arduino, power regulating circuit, servo outputs, a couple LEDs, a motor driver, and a few extra pins, and that's what I came up with. Any suggestions/comments?  :)

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131