Go Down

Topic: Termistor (Read 1 time) previous topic - next topic

Haavard GJ

I have achieved a Produal Teat ntc 20 that is a termistor that is 20k when its 25 degree celcius, by putting a 20k resistor on the other side of a voltage divider, i can get a reading of about 10-40 degrees (according to data sheet). but is it possible to expand the measuring area somehow? aka use other resisistors to increase the voltage divider?

may be a simple soulution, but i'm tired, and my head is not working optimal =P


Is a termistor the main part of a Terminator?
If it was designed by man it can be repaired by man.


The table shows resistance going from 609? at 120°C to 1,659,082 at -50°C.  You should be able to measure the whole range by using the thermistor as part of a voltage divider and measuring the voltage.  Since you didn't say, I'll assume your 20K resistor is used as a pull-up (connecting the pin to +5) and the thermistor is used as a pull-down (connecting the pin to ground).

float voltageAcrossThermistor = (analogRead(A0) * 5.0) / 1024.0;
float resistanceOfThermistor = 5.0/voltageAcrossThermistor * 20000 - 20000;

Then you can use a linear interpolation of the Temperature/Resistance table to get the temperature from the resistance.
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp



Ok. Take a look at:

Learn how to find this kind of stuff by using Google advanced search: http://www.google.com/advanced_search  and in the "site or domain:" field put "arduino.cc"..  Then your search terms. Try "thermistor"  :)

Regards, Terry King terry@yourduino.com  - Check great prices, devices and Arduino-related boards at http://YourDuino.com
HOW-TO: http://ArduinoInfo.Info

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131