Go Down

Topic: ADNS 6090 + Arduino Uno (Read 1 time) previous topic - next topic


Hi Guys,

I am programming an optical navigation sensor ADNS 6090 sensor with Arduino. I can get some values by accessing some register but for normal operation (getting the delta x and delta y) value, I need to burn a srom file (provided by sensor's company).

the srom file is provided into two format. one with .inc extension (that have the bytes in sromTable) and another normal txt with a byte per line (in total 1986 bytes) which are without "0x" prefix.

Does someone know, how to burn a srom file (anscii file) to the sensor through Arduino? Has anyone programmed ADNS 6090?

-- Nitin



according to the datasheet u can send commands via the serial interface (there seems to be some basic firmware on the ADNS6090)...
first u write to the SROM enable register twice...
then to the SROM load register once for each firmware byte...

u dont need an extra memory chip...
u can just read from the arduino flash and send it via the serial interface...


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131