Go Down

Topic: ATmega1284P: End to End using 1.0 IDE (Read 76 times) previous topic - next topic

theloon

#350
Apr 16, 2012, 01:59 am Last Edit: Apr 16, 2012, 05:36 am by theloon Reason: 1
I use a magnifying headset, it's the only way I can solder SMD 1206 parts but I've gotten pretty good at it and I'm ready for 805 parts now. At age 51 and wearing glasses since I was a kid I'm surprised I can still manage. It's easier without 5 cups of coffee first.  :D

pito

#351
Apr 16, 2012, 08:36 pm Last Edit: Apr 17, 2012, 03:25 pm by pito Reason: 1
..with our 25-30y experience we have to switch to chips in BGA packages. There is an advantage for us when we do so - we do not need to see the chip's pins/pads (balls?) when soldering it..   :smiley-eek:  :D

Graynomad

I don't want to see anything's balls while soldering, I think I'll stick to SOICs.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

theloon


CrossRoads

and watch the solder splashes ...
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Go Up