Go Down

Topic: Bad Link on Mega2560 Hardware Page to: Tutorial - How to change firmware on 8u2 (Read 819 times) previous topic - next topic

Zwilrich

On the Mega2560 hardware page http://arduino.cc/en/Main/ArduinoBoardMega2560, at the end of the Programming section, it says:  See this user-contributed tutorial for more information.  The problem is that link gives an error:  You are not allowed to access this section.  From what I can tell the tutorial has been moved to http://arduino.cc/forum/index.php/topic,111.0.html

Zwilrich

Bump.

I would change the link but I don't know for sure if the link I posted in my first message is correct because I can't read the original link.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy