next topic »

[on:]

The voltage for Logical "0 "is 0 volt or 5 volt?The voltage for logical "1"?I want make serial communication with mobile phone sony ericsson k700i.My phone Tx is always 2,7 volt and Rx is 0 volt with no command.Any idea?

[Reply #1 on:]

The DC voltage for a high (1) is 5V. 

However, if the pin is transmitting it means the signal is toggling 0 to 5 to 0.  On average, this means you would measure a DC voltage of 2.5V.  It is not surprising you see 2.7V.

You really an oscilloscope to see the full voltage.

[Reply #2 on:]

I make serial comunication Arduino Mega328 with mobile phone Sony Ericsson K700i.I test it with serial monitor.Send "AT" and reply "O","K".How i read a sms for control a led on/off?Could reset the pdu mode and use text mode for this phone or support only PDU mode?

[Reply #3 on:]

Hi i make the code for communication Arduino and Sony Ericsson K700i.....

Code:

char incomingByte;
void setup(){
  delay(10000);
  Serial.begin(9600);
  delay(3000);
  Serial.println("AT+CPMS=\"ME\",\"SM\"");
  delay(6000);
  Serial.println("AT+CMGR=1");
  //Serial.println("AT+CMGD=1");
  delay(6000);
}

void loop(){
  delay(3000);
  if (Serial.available()>0){
    incomingByte=Serial.read(),BYTE;
    Serial.println(incomingByte);
   
  }
}

I have problem with reply sms display pdu only phone number and date ,time no text ....