Go Down

Topic: 2 meters of LPD8806 strip on a Wheelchair Project - VIDEO (Read 952 times) previous topic - next topic

Cranium

Dec 06, 2011, 11:10 pm Last Edit: Dec 07, 2011, 11:34 pm by Cranium Reason: 1
My friend, Corey, wanted to upgrade the 4 white leds he used to see tight corners at night navigating in the house and to illuminate his chair a little if he were wheeling down a street after dark for safety reasons.

I thought a couple meters of Digital Addressable RGB LED Strips around his chair would be a good solution. These gave me the ability to provide him some good safety lighting at night as well as some fun lights everywhere else.

This is an Arduino based controller running on an atMega328 microprocessor on a home etched PCB. Power is provided off one of his chair's batteries and regulated down to 5V through a beefy 50W 10A capable regulator. Under the right armrest, there is a small box that contains the On/Off switch as well as a button to change lighting modes of the strip. The strip is hot glued on some aluminum angle we mounted on the back an under the seat of the chair. The angle was anodized to make it more reflective and does very well.

I currently have 17 lighting sequences programmed with 15 being active. Initial prototypes utilized a sound level monitor but he decided he didn't want that so it was disabled. On the PCB, I added the possibility of a couple of future upgrades including a couple 1W leds, another button, and a potentiometer.

He can now see and be seen much better!

http://www.youtube.com/watch?v=9zQvEhkedRc

Go Up