Pages: [1]   Go Down
Author Topic: ISAAC 32 robotics system  (Read 702 times)
0 Members and 1 Guest are viewing this topic.
costa mesa, CA, united states
Offline Offline
Full Member
***
Karma: 0
Posts: 135
/* no comment*/
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,
I just got a used ISAAC 32 robotics system(http://www.ifirobotics.com/isaac-system-overview.shtml) and have no idea how to use it.
All I know about it is that it is from the early to mid 90's and runs off of BASIC Stamp programming.
1) How do I attach it to a computer.
2) How do I declare the pins in the program.
3) How do I wire it.
4) What voltage does it runs on.
Any help is needed.
Thanks,
Jaredpi
Logged

Seattle, WA USA
Online Online
Brattain Member
*****
Karma: 551
Posts: 46257
Seattle, WA USA
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
and runs off of BASIC Stamp programming.
Then it probably doesn't have an Arduino in it.

Quote
1) How do I attach it to a computer.
Duct tape?

Quote
2) How do I declare the pins in the program.
What pins? What program?

Quote
3) How do I wire it.
Using some wire, most likely.

Quote
4) What voltage does it runs on.
Didn't you say that you were the one with the device?
Logged

DeKalb, IL USA
Offline Offline
Full Member
***
Karma: 0
Posts: 243
KB9SXU
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

By browsing to the link you posted I noticed that have a "reference guide"  It answers most if not all of your questions.  Once you review that and have questions on how to interface it with an Arduino I'm sure someone will be glad to help you.
Logged

Jeff K - JKDevices.com - home of the MegaMini

Pages: [1]   Go Up
Jump to: