Pages: [1]   Go Down
Author Topic: Yet another XY plotter - in Fischertechnik  (Read 1007 times)
0 Members and 1 Guest are viewing this topic.
Copenhagen, Denmark
Offline Offline
Edison Member
Karma: 33
Posts: 1225
Have you testrun your INO file today?
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Did this during the summer.  8-)

It is intended as a prototype - to prove that I could control motors with the Arduino with my software. This was DC motors with a feedback switch (motion, not position). Not shown on the videos is that fact that the Serial IO is done non-blocking (doing my own buffering) and there is an additional temperature monitoring (not used here).

The mechnics is not as good as might be done with Fischertechnik. I've got a slack in the way the pen is held so it may be off by ½cm before it draws. Also a minor bug, the carriage may move before the pen has reched the up or down position. (Fixed that later, didnt do a new video). I also rebuild the model, but couldnt get the pen mechanics much better. This is my Fischertechnic from 40 years ago.

The software on the laptop is in Delphi V5 which communicates to the Arduino, there is XOn/Off flow control, and it can take keyboard entry or spool a file with coordinates (a limited set of GCode commands)

Ah, yes, almost forgot  smiley-wink  - the links:


Offline Offline
Sr. Member
Karma: 1
Posts: 290
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Looks nice! Need to get my fischer technik out of the closet and start building!

Pages: [1]   Go Up
Jump to: