Go Down

Topic: Test for signal ( wave) on an IC. (Read 2151 times) previous topic - next topic


I do board level repair on SMPS in LCD , TV Monitors etc. Some times it is necessary to look up an IC data sheet and check for a proper wave on a certain pin to verify it is working using an oscilloscope.

Is there a way to test for that signal or wave with an arduino ?

From what i have read so far the arduino oscilloscope projects will not have enough bandwidth to do this.

I am new at this and please correct me on my thoughts.

I would like to use arduino to be able to test if a PWM ic on a SMPS is working or not. Or check the MCU IC on the mainboard of an LCD tv just to see if it works.

Any thoughts on this is welcome .

Nice to meet you all and thanks for your input.


Try searching for "Arduino logic analyzer" rather than "oscilloscope" ?
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]


Thanks MarkT I will try to research it.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131