Pages: 1 [2]   Go Down
Author Topic: Questions about servos  (Read 1260 times)
0 Members and 1 Guest are viewing this topic.
Miramar Beach, Florida
Offline Offline
Faraday Member
**
Karma: 150
Posts: 6130
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

That is correct. I lied about that.
I lied about my knowledge of the ethernet shield.
I lied about my knowledge of the C programming language.
I lied about everything.

Good enough?

Actually, I don't care what you think...
Logged

0
Offline Offline
Tesla Member
***
Karma: 145
Posts: 9698
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The below has some info, but as well could be driven by speculation. An O-scope and a torque measuring setup is probably needed to verify the suspect facts.

http://www.societyofrobots.com/actuators_servos.shtml
Logged

Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   smiley-cool

Pages: 1 [2]   Go Up
Jump to: