Go Down

Topic: Questions about servos (Read 2995 times) previous topic - next topic

SurferTim

That is correct. I lied about that.
I lied about my knowledge of the ethernet shield.
I lied about my knowledge of the C programming language.
I lied about everything.

Good enough?

Actually, I don't care what you think...

zoomkat

The below has some info, but as well could be driven by speculation. An O-scope and a torque measuring setup is probably needed to verify the suspect facts.

http://www.societyofrobots.com/actuators_servos.shtml
Google forum search: Use Google Search box in upper right side of this page.
Why I like my 2005 Rio Yellow Honda S2000  https://www.youtube.com/watch?v=pWjMvrkUqX0

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy