I am trying to figure out how to connect VU meter leds on speakers to give visibility to the audio signal that they will play.
This is as part of an installation and, because of its location and design, it could be a little complicated. The set up is out side, so everything needs to be waterproof, while the amps (that will power all the speakers) will be in another place covered.. so there will be long wires going all the way to the speakers, and I would like to avoid adding other cables running from the amp to the speakers, so I was hoping to use just the power running on the speakers cable. We found this kits: http://store.qkits.com/moreinfo.cfm/FA102
, but they are pretty expensive and would be good to find something in europe..
Any solutions or ideas would be much appreciated! Thanks a lot..