Go Down

Topic: problem with groove lcd shield plyg & ready (Read 911 times) previous topic - next topic


Hello All,

I'm too newbie in electronic's topics and I recently bought an arduino pack in electan. This pack includes a large amount of arduino shields listed here: http://www.seeedstudio.com/wiki/index.php?title=GROVE_-_Starter_Bundle_v1.1b#Serial_LCD.

The problem is that I have arduino IDE 1.0 and in this page says that I need to install SerialLCD Libraries only rather than the NewSerialSoftware ..etc.

I done this and I try to do a simple example writing hello world in the LCD Display. The result is that the LCD leds are on ( there are electricity ) but nothing in the Screen.

I tryed to install newSerialSoftware library but in arduino ide 1.0 it crash. Some one else have the same problem? Can some one help me please?

Thanks a lot in advance.




Where did you install the library?

in the /library folder of the Arduino IDE as the ReadME says.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131