Pages: [1]   Go Down
Author Topic: Can not upload Arduino Duemilanove ATmega328  (Read 379 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have got two Arduino Duemilanove ATmega328 from ebay (Hongkong)

I can not upload the sketch I get the error message:

avrdude: stk500_getsync(): not in sync: resp=0x00

Serial loop-back is working

Pin 13 is blinking
Logged

Santa Fe
Offline Offline
Full Member
***
Karma: 1
Posts: 208
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

if you are using the robomoto board then rev1.0 of the Arduino Ide won't work. try the 0021 rev.  I got it to work for me.
Logged

Fort Lauderdale, FL
Offline Offline
Faraday Member
**
Karma: 71
Posts: 6144
Baldengineer
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Try selecting both the "Duemilanove 328" and "Uno" boards in the IDE. 

Since you got it from eBay, it is going to be tough to tell what was done with it.  The clone boards from Amazon and eBay generally have the most problems.
Logged

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.c

Pages: [1]   Go Up
Jump to: