Go Down

Topic: Standalone XBee TX (Read 572 times) previous topic - next topic

phantom89

How can I configure (Using XCT-U) and Series1 XBee module(standalone) to collect data form an analog sensor and transmit it to another series1 XBee module which is connected to a Arduino UNO ?

strykeroz

Hi phantom89,

I've not tried this personally, but did read a similar use over at Adafruit for the tweet-a-watt project outlined here http://www.ladyada.net/make/tweetawatt/

This page http://www.ladyada.net/make/tweetawatt/config.html steps through configuring the bees to talk to each other.

Hopefully that gets you started in the right direction, Geoff
"There is no problem so bad you can't make it worse" - retired astronaut Chris Hadfield

phantom89

Thanks strykeroz... Hope itll be useful....

Go Up