Pages: [1]   Go Down
Author Topic: A ZIF Arduino Programer  (Read 1082 times)
0 Members and 1 Guest are viewing this topic.
Toronto, Canada
Offline Offline
Edison Member
*
Karma: 2
Posts: 1234
"Keep it R.E.I.L. - "Research, Experiment, Investigate and Learn"
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi guys;

I just finish testing my DIY ZIF Arduino Programer.  It simply a 28 pins ZIF socket so you can place a Ardiuno chip - ATMega328P with the bootloader, the standard components ( push-button, decouple cap, crystal with caps and limiting resistor amd led - on indicator and pin 13 ) with a typical Ardiuino chip and a USB - serial small board --> http://arduino.cc/en/Main/MiniUSB. Just select the serial port and Arduino Pro ( 5 V - 16 MHz ) in Tools. And you are ready to program your Arduino.

Here my test program.

Code:
void setup() {               
  // init pin 13
  pinMode(13, OUTPUT);     
}

void loop()
{
  blinkfast();
  delay(2000);
}

void blinkfast()
{
   for (int i=0;i<5;i++)
   {
     digitalWrite(13, HIGH);
     delay(250);
     digitalWrite(13, LOW);
     delay(250);   
   } 
}


The code is simply a blink - blink 5 time and wait for 2 second. Press reset, work fine, pin 13 flash once.

So my project pass : test one, test two and QC.

Here a picture.


* zif-arduino.jpg (121.65 KB, 1024x768 - viewed 58 times.)
Logged

Pages: [1]   Go Up
Jump to: