Go Down

Topic: l293dne motor driver problem (Read 1 time) previous topic - next topic

miros

Jan 23, 2012, 06:38 pm Last Edit: Jan 23, 2012, 07:08 pm by miros Reason: 1
Hi guys,
I have litlle problem with l293dne.i was making this: http://letsmakerobots.com/node/2074
but it didnt work. i realized when i get 5v to input(pin 2 on l293dne) it does nothing however when it get ground to input it works.did it happen to you? can i fix it?

MarkT

We need a little more information perhaps - what are the other inputs doing?  You realize that for the motor to turn you need to drive one wire high and the other low - so the two inputs for that motor need to be opposite logic levels to produce motion.
[ I won't respond to messages, use the forum please ]

miros

i fixed it really easy. i connected 10k resistor from input pins on l293 to ground. i also connected input pins to arduino and it works.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy