Go Down

Topic: using 9 Degrees of Freedom - Razor IMU - AHRS (Read 15159 times) previous topic - next topic


Hii... Nice to meet you all.

I just get this module (9 DOF Razor IMU) with ATMEGA 328 from sparkfun.com. Then i connect to laptop using FTDI Basic 3.3V. Start Arduino 0021 software, choose board : Arduino Pro or Pro Mini (3.3V, 8MHz) w/ ATMEGA 328. Then open the serial monitor, i get this :





Endless of output.

What is it mean?
Why i didn't the instruction to follow? (as tell by somebody in this topic)

I try to type 1 then click send on serial monitor, but no change on the output. Then i try other number until 5, nothing i get. The output no change. Also i already push reset but still no change.

Does anybody have manual for this module?

Please Help, thanks

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131