Go Down

Topic: Drive Belt (Read 1 time) previous topic - next topic


HI everyone, building a camera slider here and was wondering if anyone had sources for cogged drive belts and worm screws and a way to attach them to a steppers spindle?

The track is 39" long and the stepper motter is pulling and pushing a dolly along it from one end.


Commercial source would be Boston Gear.

You might also check and see if you have a local bearing and power distribution distributor as they often carry timing belt drive parts, sprockets and chain and gears. And they are often very competitive on pricing.


The Makerslide Store has some inexpensive options.

If you can be more precise as to the diameter of your stepper's shaft you'll get a better answer.


servo city may have hardware of onterest.

Google forum search: Use Google Search box in upper right side of this page.
Why I like my 2005 Rio Yellow Honda S2000  https://www.youtube.com/watch?v=pWjMvrkUqX0


Just purchased some belts and pulleys from here:


And here is the manufacturer site with belt/pulley calculator:



servo city may have hardware of onterest.


Oooh, oooh! That'll come in handy for my ball mill project. Thanks.
... it is poor civic hygiene to install technologies that could someday
facilitate a police state. -- Bruce Schneier

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131