Is the Servo library working?
I plan on using Tiny 84 and 85 at 8MHz
for tiny robots
and I need the Servo Lib
the SoftwareSerial Lib
the EEPROM Lib
and the analog read (if there is support)
After successful tests I'll make dedicated boards for these chips. The idea is to have 6 and 3 servo connectors plus serial or sensor connectors on the boards. All servo positions will be saved in the EEPROM so the user can connect the board to the PC using a FTDI cable and set new servo positions as new moves that are later played back directly on board.
So I am willing to do any tests you can throw at me.
I'll switch to SoftwareSerial and report back
NSS.. can be simplified a little bit, especially when you constrain to a few bit-rates only
It can be re-written using USI
The size of the receive buffer must most likely also be reduced.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16