Pages: [1]   Go Down
Author Topic: DFRobotics LCD shield pinout DFR0009  (Read 831 times)
0 Members and 1 Guest are viewing this topic.
Johannesburg. UTC+2
Online Online
Faraday Member
**
Karma: 91
Posts: 4215
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey all,

I've had a DFR0009 shield for a while but only today realised which digital pins are broken out. As far as I can tell, they're not documented. The analog pins and a few others on the bottom edge are labelled on the board; for some reason the pins at top-right are not labelled.

The DFR0009 uses digital pins 4-10, which means we should have access to pins 0-3 and 11-13. Well we do... the pins (holes actually) at top-right of the board are, from the right, 0, 1, 2, 3, 11, 12 and 13. See pic below...

Hope this helps other users...


* dfr0009 pins.png (61.65 KB, 357x226 - viewed 49 times.)
« Last Edit: March 31, 2013, 11:38:44 am by JimboZA » Logged

Roy from ITCrowd: Have you tried turning it off an on again?
I'm on LinkedIn: http://www.linkedin.com/in/jimbrownza

The Netherlands
Online Online
Edison Member
*
Karma: 49
Posts: 1611
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks for mentioning this.
Iv'e got a similar board (doesn't say DFRobot or any other brand), and the reason for the missing labels seems to be a lack of space for that.
I just happened to see this myself this weekend and was planning to find out what pins are available there, you beat me to it so thanks.
Logged

Have a look at "blink without delay".
Did you connect the grounds ?
Je kunt hier ook in het Nederlands terecht: http://arduino.cc/forum/index.php/board,77.0.html

Johannesburg. UTC+2
Online Online
Faraday Member
**
Karma: 91
Posts: 4215
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Well if yours is similar, it might not be identical. Probably worth taking a few minutes to check them with your meter to see exactly where the come from....

Logged

Roy from ITCrowd: Have you tried turning it off an on again?
I'm on LinkedIn: http://www.linkedin.com/in/jimbrownza

Pages: [1]   Go Up
Jump to: