Go Down

Topic: Problem with triggers (Read 558 times) previous topic - next topic



I wrote some code to create switches on my Arduino 2560 MEGA board. I would like to have program that allows me to move the menu numbers. To do this I used RTC library to set up some delay for my inputs. Unfortunately this code do not work properly. Could you please help me with that?

Thank you in advance for your support.

Best Regards


Unfortunately this code do not work properly.

Without knowing what it does, what you expected it to do, and how those two differ, all we can do is offer condolences and wish you luck.

That's too bad. Good luck fixing it.
The art of getting good answers lies in asking good questions.



I have solved the problem today. :) There were some logical mistakes in the code.

Thank you very much for response.

Best Regards

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131