Go Down

Topic: Arduino Uno + Wireless proto shield + Wifly module (Read 15 times) previous topic - next topic


Can you post a link to the WiFly module or shield you are using?



I used the WiFlySerial library from arduinology and the combo of the WiLFy RN-XV, Uno and Sparkfun XBee Shield and have a simple demo working. You can check it out here:

I was banging my head against the wall until I saw a post about removing the diode on pin3. After that it began working.



I am using wifly shiled from sparkfun. Here is the link: http://www.sparkfun.com/products/9954

Okay so you do have an SPI interface to the WiFly, so you're on the right track.


I'm using this one called the RN-XV
here is the link:  http://www.sparkfun.com/products/10822

i have a thread going on a project I am working on using it.  Your thread here is very good and also helpful :)  this is one handy little device :)


Go Up