Go Down

Topic: Using follow sketch in processing to control arduino? (Read 537 times) previous topic - next topic

I have all connections made to run an rc car with the arduino IDE but I'm going another step and wanting to use processing sketch follow to control it. Basically using the mouse to control it via processing.


Too much static interference from the mouse and rc transmitter I have connected to the arduino. The switch case code I have works well enough.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy