Pages: [1]   Go Down
Author Topic: Using follow sketch in processing to control arduino?  (Read 446 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have all connections made to run an rc car with the arduino IDE but I'm going another step and wanting to use processing sketch follow to control it. Basically using the mouse to control it via processing.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'll send the code i have later.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Too much static interference from the mouse and rc transmitter I have connected to the arduino. The switch case code I have works well enough.
Logged

Pages: [1]   Go Up
Jump to: