To use your Arduino board to burn a bootloader onto an AVR, you need to follow a few simple steps.Upload the ArduinoISP firmware (in Examples) to your Arduino board.Wire your Arduino board to the target as shown in the diagram below.Select the item in the Tools > Board menu that corresponds to the board on which you want to burn the bootloader (not the board that you're using as the programmer). See the board descriptions on the environment page for details.Use the Burn Bootloader > Arduino as ISP command.
With the above I would need to keep on re-loading the ISP sketch...?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16