I'm making an Arduino shield for this LCD
I'm using the library for the DFRobot ST7920 128 X 64 LCD and it works without a problem, both in serial as in parallel mode. But the weird thing is, is that the parallel mode is a bit slower. In SW serial I got a refresh rate of 6 to 7 frames per sec and in 8bit it goes down to 4 to 5.Is this normal behavior or am I doing something wrong?
Labelled: "Open Jumper, 12864"Size: 47 x 38 x 4mmSupply Voltage: VCC 4.5 to 5.5V (built-in booster circuit, no negative voltage required)Controller: UC1701, Based on: 12864Display: 128x64Interface: SPI
u8g.setContrast(0); // in the setupu8g.drawFrame(0, 0, 127, 63); // in the picture loop, helps determine screen edges / locations
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16