Go Down

Topic: Digital Projection Clock Interface Help (Read 650 times) previous topic - next topic

shaemmerling

HI everybody, i found this older ceiling projection clock part the other day and was wondering how i could interface it with my arduino. there is an IC under a glob of epoxy im almost sure, 8 pads for connections on the board only 7 being used, 2 for powering a red LED. The 5 wire ribbon cable must contain at least 1 power and 1 GND, meaning it uses 3 wire communication? Im not really sure. it uses the red LED behind and older style LCD That projects up to 4 digits with a colon in the middle. Any ideas on how to use it? heres a link to some pictures.http://srhaemmerling.webs.com/apps/photos/album?albumid=12982165

johnwasser

Is it still hooked up to the rest of the clock?

Do you have access to a logic analyzer or even just an oscilloscope?
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy