Pages: 1 [2]   Go Down
Author Topic: How to eliminate noise of the LM35 connected to Analog pin of Arduino..?  (Read 5511 times)
0 Members and 1 Guest are viewing this topic.
SW Scotland
Offline Offline
Edison Member
*
Karma: 17
Posts: 1386
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Sorry, but the drawing you provided is totally irrelevant to the problem.  You were requested for actual as-built circuit, not a drawing from the vendor data sheet  -  which, by the way calls for a 0.1microfarad on the output as well as a 0.33 on the input, both of which should be as close as possible to the regulator pins.  Have you considered the possibility that your regulator may be defective.
Logged

INDIA
Offline Offline
Sr. Member
****
Karma: 0
Posts: 382
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes I have tried other 7805s ther behaved the same...
Only when I use the small 7805 (TO- 92) there is no problem...
Logged

Pages: 1 [2]   Go Up
Jump to: