Go Down

Topic: Errors in Uno R3 Reference Design CAD files... (Read 1 time) previous topic - next topic

westfw

On another (randomish) forum, someone was flaming about errors in the published Uno R3 Reference Design , but they don't seem to have reported them on any of the actual Arduino-related forums.  So I will...

In the R3 Schematic (both the EAGLE .SCH file and the pdf version), the USB power signal coming off of the fuse is mislabled (un-labled) n$2, when it should be "USBVCC":


And in the .BRD file for the PCB, there is a missing trace connecting the overvoltage protection circuitry on one of the USB signals to the USB Shield:


Interestingly, if you were to have a board made based on these files, it should still work.  The misnamed signal has a PCB trace connecting it to the correct places, and the missing trace is in "protection" circuitry that shouldn't normally be relevant (and was not present prior to Uno.)

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy