Pages: [1]   Go Down
Author Topic: Trouble uploading to Arduino NG ('TX' flashing rapidly)  (Read 378 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I just broke out my old Arduino NG rev.c (Atmega 168) and I can't seem to upload sketches.

On a Mac:
Board: "Arduino NG or older w/ ATmega168"
Serial Port: "/dev/tty.usbserial-BLAHBLAHBLAH"

When I click upload, 'RX' and 'TX' flash once, then 'TX' begins to flash rapidly and doesn't stop. The program on the computer says the "Binary sketch size" and the Uploading... status bar never finishes. If I press the reset button on the Arduino while this is happening, I get "avrdude: stk500_getsync(): not in sync: resp=0x10".

Any help is appreciated!
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

If it helps, I get the same behavior with a different computer. Does a flashing TX mean anything particular about the Arduino?
Logged

Pages: [1]   Go Up
Jump to: