Go Down

Topic: L293NE stepper control (Read 2275 times) previous topic - next topic


I am trying to design some modules which are meant to drive a stepper each using the L293NE driver IC from TI. The design drives the stepper based on the results of sensor inputs, ie. pushbutton and IR rangers. The design is intended to be modular in nature, and needs to be able to communicate with as many or as few modules in the specific application. The questions are...1 how many pins(to and from uC) minimally am I going to need to make this work with all desired functions?2 How to interlink each module for communication with eachother, keeping in mind that there could be as many as 10 modules or as few as two in any given implementation.


can you draw your configuration?
Prob you need:
 -L293NE              4 pins   out
 -Pushbutton         1 pin    in
 -IR                     1 pin     in
 -COM          appr. 4 pins   in&out
                          10 pins

RTFM & start with something as simple as possible

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131