Go Down

Topic: Reading a IR reciever (Read 1 time) previous topic - next topic


I bought a set, which was for checking if the remote control works.. Instead i thought i'd try to connect the IR reciever to the arduino-board to get a read, but i can't seem to get anything out of it.

It looks just like a LED, but is clear.

I've tried ground + digital pin 10 and ground + analogue pin 3 (mostly since all the other pins are taken), but i can't get any other value than 0.

Any help is appreciated



Hello Seltar,

  Take a look at http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1152894029. I've made an SIRCS IR decoder. It's in french but you can ask me if you have some questions.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131