Go Down

Topic: Optoisolator TLP521 (Read 1 time) previous topic - next topic

Hi all,
I have a simple question: I would like to use an optoisolator to control some devices from digital output of arduino board. In my case optoisolator is a TLP521, can I connect directly digital output to anode and cathode to gnd or I have to use a resistor between digital output of arduino and anode of TLP521?

many thanks
Fabrizio

admin

Ciao Fabrizio


You should use a 270 ohm resistor from one of the arduino pin and connect it to the anode of the optocoupler
the cathode is connected to ground.

massimo



Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy