Go Down

Topic: Arduino bootloader problem? (Read 1 time) previous topic - next topic

texasnoise

I am not able to successfully load programs to my arduino. Apparently there is a bootloader on the chip because when I plug it in (usb) a small led blinks near the 14 pin. However, when I plugin an led in the 13 and grnd it does not blink. Does this mean that there is a problem with the bootlader that the arduino shipped with? I had wanted to use this in an installation with range finders communicating with Max/MSP.
Any suggestions?
thanks,
Ronnie

mellis

This is an Arduino NG?  If the on-board LED blinks/flickers, the bootloader should be on-board.  What error do you get when you try to upload?  Have you checked the FAQ?  http://www.arduino.cc/en/Main/FAQ#upload

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy