Pages: [1]   Go Down
Author Topic: Arduino bootloader problem?  (Read 938 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am not able to successfully load programs to my arduino. Apparently there is a bootloader on the chip because when I plug it in (usb) a small led blinks near the 14 pin. However, when I plugin an led in the 13 and grnd it does not blink. Does this mean that there is a problem with the bootlader that the arduino shipped with? I had wanted to use this in an installation with range finders communicating with Max/MSP.
Any suggestions?
thanks,
Ronnie
Logged

Forum Administrator
Cambridge, MA
Offline Offline
Faraday Member
*****
Karma: 12
Posts: 3538
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

This is an Arduino NG?  If the on-board LED blinks/flickers, the bootloader should be on-board.  What error do you get when you try to upload?  Have you checked the FAQ?  http://www.arduino.cc/en/Main/FAQ#upload
Logged

Pages: [1]   Go Up
Jump to: