Go Down

Topic: arduino clone (Read 1 time) previous topic - next topic

josh97531

i had a look at some other arduino clone circuits and i designed my own basic arduino clone the circuit is attached below as i am new to all this i am asking to see if it will work i think it will but i am not sure

florinc

It looks ok.
You will need to add a 6-pin header to connect to an FTDI breakout, for uploading sketches.

CrossRoads

He does have an FTDI header. Not organized to accept an FTDI Basic as is, but easily re-organized. Needs a 0.1uF cap between the reset on the connector pin and the reset pin.  Having the 0.1uF caps across the VCC, AVCC, and AREF pins to gnd also helps to show that decoupling is understood.
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

kf2qd

Just the de-coupling caps, other than that it looks good.

josh97531


Go Up