I see you are in the UK, have you seen the FPVUK forum post(s) regarding 459MHz use?It would be good to see you over there.http://www.fpvuk.org/forum/index.php?topic=2551.new;topicseen#new
What are your plans for the smaller PCB?I'd be very interested in a couple of smaller (Futaba module compatible) boards - I'm willing to assist with costs.
Devonian are you willing to modify the interesting features of openlrs firmware (failsafe, rssi etc.) to work on this nice hardware?Edit: Zitron hope you received my pm with my address. Zitron hope you retain the same connections on your board so more code fluent friends on this forum can help me out with the code
Yeah I can send you the 3 rev 1 boards msev wanted. I can send him the new boards if he still wants them.
Hi Zitron,Discover the secret - where do you manufacture the PCBs?
OK guys sorry I can't keep giving away boards for free. From now on I will charge a small fee (£2 per board) just to cover my costs.
Before you decide to start this project, make sure you can write code for arduino, ideally have some knowledge about SPI communincations, can solder SMD packages, and can find all the components that you need, listed in the BOM pdf attachted in a previous post. I can help, but I don't have time to answer all the questions.
I can solder SMD and get all the components needed; I have lots of open source arduino projects done but... I don't write arduino code... if you do not mind sending me the actual code, as well as any updates, I think I'll have no problems. If you do not mind that your project is shared, I think it might bring some progress in the project through some friends. But as I said before ... I do not write code... Zitron What do you think? It is worth I join the project?
Zitron sorry for the late response.. You can send/sell the pcbs that you reserved for me to other guys...I'll probably make my own diy single layer boards and use an arduino nano..I'll make the connections per flytrons schematic so that I won't need to tinker too much with the code..I'll make the nano removable so that I could remove it from the board when uploading new sketches (since 5V would kill the rfm22b)..I would take yours if there would be a possibility to easily port openlrs code...but its a bit too complicated for me..Hope you continue with your nice project and post code...Hope then when you write your code for lrs you'll still have some pcbs to sell .