Go Down

Topic: Attiny85 and TLC5940's (Read 1 time) previous topic - next topic

funkyguy4000

So I'm confused still, I've researched it and all.
I can't figure out how to control the TLC5940 with the ATtiny without a library.

I'm not at the point to where i can look at a datasheet for a microcontroller and then program it to tell it how to control a driver, anybody wanna help out?
Accelerate to 88 miles per hour.

funkyguy4000

Accelerate to 88 miles per hour.

johnwasser

It is possible that the TLC5940 library you want to use will work on the ATtiny85.  I recommend you get your program working on the Arduino UNO first.  Once it is working there you can worry about porting it to the smaller chip (1/4 the program space and 1/4 the RAM space).

Is there some reason why you must port it to the ATtiny85?
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

funkyguy4000

I have little space on the project board and I may need to add some caps for the project to work, those caps have no room on the board with the atmega.
Accelerate to 88 miles per hour.

Go Up