Go Down

Topic: Eagle / OSH Park, how to get UNplated hole with pads (Read 2764 times) previous topic - next topic

kg4wsv

I'm trying to get a 2x4 jumper arrangement - two address lines, each jumpered to one of 4 other lines to select an address.  The target PCB is quite small - about 1" x 0.75" - and I don't want to increase the board size by 50% just to get configuration jumpers.

I think I'll end up using wires as jumpers (which I was originally trying to avoid), so I can do it with a total of 6 plated through-holes.  To save space I may see if I can do it with slightly oversized vias and 30ga wire.

-j

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy