Pages: [1]   Go Down
Author Topic: Problems whene I conect the Arduino UNO Board to my computer (Windows 7 64-bit)  (Read 524 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi whene I conect the Arduino UNO whith a USB to my computer. Then I can't see the I don't get any comunication whit the Arduino UNO to my computer. But the Arduino get power from the computer. So what do I wrong.

Logged

0
Offline Offline
Edison Member
*
Karma: 8
Posts: 1249
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

do you have the IDE installed?

what version?


what board do you have selected?

what com port do you have it set to? (same as the Arduino is on?)
Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have Arduino 1.0 installed on my computer. I have selectet Arduino UNO and Com port have I selected port 4 becuse it is the only one that I could use from my Arduino 1.0
Logged

0
Offline Offline
Edison Member
*
Karma: 8
Posts: 1249
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I havent 'upgraded' to 1.0 IDE (nothing but problems from what I read...for beginners at least)  smiley-wink

when you communicate or try to upload a sketch what error message are yo getting?
Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I get this error: avrdude: stk500_getsync(): not in sync: resp=0x00
Logged

Pages: [1]   Go Up
Jump to: